Motorola AC1000 User Manual page 7

Connecting the base
1. Plug the telephone line cord into the socket marked
2. Plug the power adaptor into the socket marked
plug the other end into the mains power wall socket. Switch on the mains power.
Installing and charging the cordless audio conferencing unit
1. Remove the battery cover from the back of the cordless audio conferencing unit and
plug in the rechargeable Ni-MH battery pack supplied.
2. Clip the battery cover back into place.
3. If you are charging the batteries for the first time, place the cordless audio
conferencing unit on the base to charge for at least 24 hours continuously.
4. When the cordless audio conferencing unit is fully charged,
steady on the display. Plug the other end of the telephone line cord (make sure that
one end is already plugged into the base) into the telephone wall socket.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery pack (1500mAh Ni-MH
rechargeable battery pack) supplied with your AC1000.
BATTERY LOW WARNING
If you hear a warning beep every 30 seconds during a call, you will need to recharge the
cordless audio conferencing unit before you can use it again.
When charging,
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to 8 hours talk time or up to 100
hours standby time on a single charge.
Note that new batteries do not reach their full capacity until they have been put to normal
use for several days.
Getting started
icon will scroll on the display. Once charged scrolling will stop.
1
on the underside of the base.
on the underside of the base and
icon will appear
7