Controls; Depth Adjustment Handles; Depth Guides - Toro 09701 Operator's Manual

Controls

Depth Adjustment Handles

Remove lynch pins, rotate handles to raise or lower tines
to desired depth and replace lynch pins (Fig. 17).
1
1
Figure 18
1. Depth guide
2
Figure 17
1. Depth adjustment handle 2. Lynch pin

Depth Guides

Depth guides (1 thru 27) are provided to give equal
increments for adjustment. The numbers do not relate to
measurements of depth as this changes with tine type and
amount of tine wear. Adjustment between two numbers
will give approximately .20 inches (5 mm) change in
depth. The higher the number, the deeper the tine
penetration. Always adjust each side to the same number
(Fig. 18).
18