Cleaning; Cleaning Under The Mower; Disposing Of Waste - Toro 74919TE Operator's Manual

6 2
1
g015594
Figure 107
1. Bolt
2. Spacer
3. Locknut
4. Spring
3. Place the spacer and the spring onto grass deflector.
4. Place 1 J-hook end of the spring behind the deck edge.
Note: Make sure that 1 J-hook end of the spring is
installed behind the deck edge before installing the bolt
as shown in Figure 107.
5. Install the bolt and the nut.
6. Place 1 J-hook end of the spring around the grass
deflector (Figure 107).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
4
7
3
5
5. Spring installed
6. Grass deflector
7. J-hook end of spring

Cleaning

Cleaning under the Mower

Service Interval: Before each use or daily
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the mower to the T

Disposing of Waste

Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
65
- position,
EUTRAL LOCK
position.
RANSPORT