Loose Parts; Installing The Handle - Toro 38518 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Step
1.
2.
3.

1. Installing the Handle

1. Cut the plastic tie that secures the control cable to the
handle.
Note: Hold the cable taut to ensure that it stays
connected at the bottom.
2. Position the upper handle as shown (Figure 3).
Figure 3
3. Loosely install the handle bolts, curved washers, and
knobs (Figure 4).
Description
Handle bolt
Curved washer
Knob
Discharge chute
Phillips head screws
Washers
Locknuts
Chute crank and mounting plate
Bolts
Locknuts
Qty.
1
1 Install the handle.
1
1
3
Install the discharge chute.
3
3
1
2 Install the chute crank.
2
Figure 4
4. Hook the end of the control cable spring into the
bottom hole of the control bar (Figure 5).
Figure 5
5. Fully insert the handle bolts (Figure 6).
Important: Ensure that you do not pinch the
control cable (Figure 6).
6
Use