Maintenance; Recommended Maintenance Schedule(S) - Toro 38700 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 2 hours
After the first 5 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Every 300 hours
Yearly
Yearly or before storage
Important: You can find more information about maintaining and servicing your machine at www.Toro.com.
Important: Refer to your engine operator's manual for additional maintenance procedures. For engine adjustments,
repairs, or warranty service not covered in this manual, contact the authorized engine service dealer.
Maintenance Procedure
• Check the traction cable.
• Check the broom cable.
• Change the engine oil.
• Check the engine oil level.
• Check the broom-shaft shear pin.
• Check for loose hardware.
• Clean the foam pre-cleaner (more frequently in dusty conditions).
• Check the tire pressure.
• Check the condition of the belts.
• Lubricate the broom-angle-lock pin.
• Change the engine oil (more frequently in severe conditions).
• Check the spark plug.
• Replace the foam pre-cleaner.
• Replace the paper air filter (more frequently in dusty conditions).
• Lubricate the hex shaft.
• Check the traction cable.
• Check the broom cable.
• Check the air pressure in the drive tires and inflate them to 116 to 137 kPa (17
to 20 psi).
• Drain the gasoline and run the engine to dry out the fuel tank and the carburetor at
the end of the season.
• Have an authorized service dealer inspect and replace the traction-drive belt, if
necessary.
18