Maintaining The Chassis - Toro 38700 Operator's Manual

6. Slip the traction belt out of the groove of the traction
pulley and up between the pulley and the friction wheel
(Figure 43).
1. Traction pulley
2. Belt
7. Slip the belt off the rear groove of the engine pulley
and remove the belt from the machine
Installing the Traction Belt
1. Align the traction belt between the friction wheel and
the traction pulley
2. Align the belt into the groove at the bottom of the
traction pulley (Figure
3. Pull the tension pulley outward
4. Align the belt into the rear groove of the engine pulley
(Figure 42).
Note: Release the tension pulley.
5. Move the traction-control bracket rearward and align
the hole in the bracket with the traction-control rod
(Figure 41).
6. Slip the rod through the bracket and secure the rod
with the hairpin (Figure
7. Install the broom-drive belt; refer to
Broom-Drive Belt (page
8. Install the engine cover and the belt cover; refer to step
1 of Checking the Condition of the Belts (page
Figure 43
3. Friction wheel
(Figure
(Figure 43).
42).
(Figure 42).
41).
Installing the
26).

Maintaining the Chassis

Checking for Loose Hardware
Service Interval: Before each use or daily
1. Visually inspect the machine for any loose missing
hardware or any other possible problem.
2. Tighten all loose hardware before operating the
machine.
3. Replace all missing hardware before operating the
machine.
42).
25).
27