Installing The Handle - Toro 38078 Operator's Manual

Part
Lower link
Hex flange nut
Flange locknuts
Compression spring
Worm gear
Bracket
Carriage screw
Flat washer
Locknut
Key
Specifications and design are subject to change without notice.

Installing the Handle

1. Remove the tie straps that secure the control rods to
the handle.
2. Remove the axle pins from both wheels (Fig. 2) and
slide the wheels outward on the axle approximately
one inch (2.5 cm).
Figure 2
1. Handle
2. Capscrews and curved
washers
3. Hold the handles in the installation position and insert
the traction rod through the loop in the lower traction
rod (Fig. 7).
IMPORTANT:
Ensure that the chute control rod
assembly is between the engine and the traction rod
(Fig. 3).
653
3. Axle pin
Qty
1
1
Installing the auger and traction drive control Installing the auger and traction drive control
rod
2
1
1
1
1 Installing the chute control rod
1
1
1 Starting and stopping the engine
1. Traction rod
4. Position the left handle against the left side of the
snowthrower, align the handle mount holes with the
holes in the side plate, and secure the handle with two
capscrews and curved washers until finger tight
(Fig. 2).
Note:
The concave side of the curved washer goes against
the outside of the handle.
5. Position the right handle against the right side of the
snowthrower, align the handle mount holes with the
holes in the side plate, and secure the handle with two
capscrews and curved washers until finger tight.
6. Slide the wheels inward and install the axle pin
through the holes in the wheel hub and through the
inner hole of the axle (Fig. 4).
7
Use
m-4038
Figure 3
2. Engine