Toro 30413 Operator's Manual page 34

down the unit when it is still hot and avoid directing
high-pressure or high volume spray at the bearings.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
• Brake shaft pivot bearings (5) (Figure 34)
• Traction pedal pivot bushing (1) (Figure 35)
• Front and rear axle pivot bushings (2) (Figure 36)
• Steering cylinder ball joints (2) (Figure 37)
• Tie rod ball joints (2) (Figure 37)
• King pin bushings (2) (Figure 37).
The top fitting on the king pin should
only be lubricated annually (2 pumps).
Figure 34
Figure 35
Center Cutting Unit
Note: Deck may have to be raised to expose the grease
fittings for the latch pivot and the lower link.
• Latch pivot (2) (Figure 39)
Note: The latch (Figure 38) may need to be
manually tripped to gain access to the grease fitting.
Use a prybar to close and re-open the latch
34
Figure 36
Figure 37