Table of Contents
Advertisement
connector. Turn the key to the Off position when
solid flow is observed.
4. Tighten the tube connector securely.
5. Repeat the procedure on the remaining nozzles.
Electrical System
Maintenance
Activating, Charging, and
Connecting the Battery
Every 50 hours
Battery Care
Battery type is group 24.
Important: Before welding on the machine,
disconnect the negative cable from the battery to
prevent damage to the electrical system.
Note: Check the battery condition weekly or after every
50 hours of operation. Keep the terminals and the entire
battery case clean because a dirty battery will discharge
slowly. To clean the battery, wash the entire case with
a solution of baking soda and water. Rinse with clear
water. Coat the battery posts and cable connectors with
Grafo 112X (skin-over) grease (Toro Part No. 505-47)
or petroleum jelly to prevent corrosion.
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
1. Raise the seat and secure it with the prop rod.
2. Remove the battery cover (Figure 54).
40
Warning
Advertisement
Table of Contents
