Filling The Chain Saw With Oil; Operation; Starting The Chain Saw - Toro 51888 Operator's Manual

Filling the Chain Saw With Oil

1. Place the chain saw on a flat surface and remove the battery.
2. Clean the area around the oil cap (Figure 4).
1. Oil cap
3. Remove the cap and pour oil into the chain saw until the oil
fills the window (Figure 4).
Note: Do not fill the chain saw higher than the bottom
of the fill neck.
4. Clean up any spilled oil and replace the oil cap.
Figure 4
2. Window

Operation

Important: The battery pack is not fully charged when
it is purchased. Refer to Charging the Battery Pack
(page 11).

Starting the Chain Saw

1. Set the chain saw down on a level surface.
2. Align the tongue of the battery pack with the battery cavity
in the chain saw (Figure 5).
1. Latch
3. Push the battery pack into the battery cavity until the latch
locks into place.
4. With one hand on the auxiliary handle and the other on
the trigger handle, press the trigger lock, then squeeze the
trigger to start the chain saw (Figure 6).
1. Trigger lock
2. Trigger switch
7
Figure 5
2. Tongue
Figure 6
3. Auxiliary handle