Kenwood DDX7032 Service Manual page 28

DDX7032/7032M/712
DNX7120/7220/7320
Touch Adjust
1-point being input 2-point being input
Cancel
3-point being input 4-point being input
Figure 4.7 Touch Adjust screen
Key Specifi cation
Cancel : When the Cancel button is pressed while enter-
ing the 1st point, the system transfers to the Test
Mode Main screen.
When the Cancel button is pressed while enter-
ing the other point than the 2nd point, the system
transfers to the status to enter the 1st point.
Return : Transfer to Test Mode Main screen
4.8. HPOSI Adjust screen
Adjust horizontal position of each screen.
The screen shall be transferred like; "Graphic→NAVI".
Graphic and NAVI of DNX are used in the adjustment of Dot
FREQ/Dot Phase. The HPOSI Adjust screen is shown in
Figure 4.8.
HPOSI Adjust
Next
Graphic
(NAVI)
HPOSI
Step value
<<
>>
Dot FREQ
Step value
<< >>
Dot Phase
Step value
<< >>
Cancel
Figure 4.8 HPOSI Adjust screen
Key Specifi cation
Next : Transfer to the next HPOSI Adjustment screen.
When the screen is the NAVI screen, start writing
in the nonvolatile memory.
<< : Screen toward the left.
>> : Screen toward the right.
Cancel : Transfer to Test Mode Main screen
Return : Transfer to Test Mode Main screen
If the "HPOSI NG" is displayed (i.e., in case of failure in
writing data in the nonvolatile memory), re-enter in the Test
Mode again to start over the adjustment.
4.9. iPod Authentication Chip Confi rmation screen
Check communication for iPod authentication.
The iPod Authentication Chip Confirmation screen is dis-
played in Figure 4.9.
28
TEST MODE
Touch Adjust
Wite OK/NG
Return
HPOSI Adjust
HPOSI OK/NG
Return
iPod Check
iPod Check
Cancel
Figure 4.9 iPod Authentication Chip Confi rmation screen
Key Specifi cation
iPod Check : Start checking communication for iPod
authentication.
Cancel, Return : Transfer to Test Mode Main screen
4.10. Auto Adjust screen
Carry out the automatic adjustment of Chroma / Mstar.
The contents displayed on the Auto Adjust screen are
shown in Figure 4.10.
Note: Refer to the hardware service documents for the
equipment to connect to the set.
Auto Adjust
Auto Adjust
Start
Cancel
Figure 4.10 Auto Adjust screen
Key Specifi cation
Auto Adjust Start : Start automatic adjustment.
Cancel, Return : Transfer to Test Mode Main screen
4.11. Inverter Confi rmation screen
Change the inverter frequency.
The Inverter Confi rmation screen is displayed in Figure 4.11.
Inverter Check
Low
Figure 4.11 Inverter Confi rmation screen
Key Specifi cation
Low : Set the inverter frequency at Low level.
High : Set the inverter frequency at High level.
Return : Transfer to Test Mode Main screen
iPod Check
iPod OK/NG
Return
Auto Adjust
Adjust OK/NG
Return
High
Return