Cleaning The Engine Cooling Areas; Servicing The Air Cleaner - Toro 07253 Operator's Manual

Changing and Draining the Oil
1. Start the vehicle and let it run for a few minutes to
warm the oil.
2. Park the machine on a level surface, set the parking
brake, turn the ignition off, and remove the key.
3. Raise the bed and secure it with the prop rod.
4. Disconnect the spark plug wires and battery cables.
5. Remove the drain plug (Fig. 27) and let the oil flow into
a drain pan. When the oil stops, install the drain plug.
Note: Dispose of the used oil at a certified recycling center.
Figure 27
1. Engine oil drain plug
6. Pour oil into the fill opening until the oil level is up to
the Full mark on the dipstick. Add the oil slowly and
check the level often during this process. Do not
overfill.
7. Install the oil fill cap and dipstick firmly in place.
Changing the Oil Filter
Replace the oil filter every 100 operating hours or yearly,
whichever occurs first.
1. Drain the oil from the engine; refer to Changing and
Draining the Oil, page 28.
2. Remove the existing oil filter (Fig. 27). Apply a light
coat of clean oil to the new filter gasket.
3. Screw the new filter on until the gasket contacts the
mounting plate, then tighten the filter an additional 1/2
to 3/4 turn further. Do not overtighten.
4. Fill the crankcase with the proper type of new oil; refer
to Engine Oil, page 27.
5. Start and run the engine to check for leaks.
6. Stop the engine and check the oil level. Add oil if
necessary.
1
2
2. Engine oil filter
28
Cleaning the Engine Cooling
Areas
Clean the rotating screen, cooling fins, and external
surfaces of the engine every 100 hours of operation or more
often under extremely dusty and dirty conditions.
Important
Operating the engine with a blocked
rotating screen, dirty or plugged cooling fins, or cooling
shrouds removed, will cause engine damage due to
overheating.
Important Never clean the engine with pressurized
water because water could contaminate the fuel system.

Servicing the Air Cleaner

Service Interval/Specification
Check the air cleaner body for damage which could
possibly cause an air leak. Replace a damaged air cleaner
body.
Ensure that the cover is sealing around the air cleaner body.
Air Cleaner Filter: Inspect after every 100 operating hours;
replace after every 200 hours or sooner if it is dirty or
damaged.
Note: Service the air cleaner more frequently (every few
hours) if operating conditions are extremely dusty or sandy.
Removing the Filter Element
1. Park the machine on a level surface, set the parking
brake, turn the ignition off, and remove the key.
2. Raise the bed and secure it with the prop rod.
3. Release the latches securing the air cleaner cover to the
air cleaner body. Separate the cover from the body.
Clean the inside of the air cleaner cover (Fig. 28).
3
Î Î
2
Figure 28
1. Air cleaner latches
2. Cover
1
3. Filter