Toro 03706 Operator's Manual page 24

Mow–Backlap lever to MOW. Reels are now spinning.
Maintain traction pedal contact with ground speed limiter
(Fig. 21) to assure consistent clip and quality–of–cut.
Figure 21
1. Ground speed limiter
1
Figure 22
1. Reel speed control
2
1
2. Traction pedal
24
CAUTION: This product may exceed noise levels of 85
dB(A) at the operator position. Ear protectors are
recommended for prolonged exposure to reduce the
potential of permanent hearing damage.
Transport
When mowing is complete, move MOW–BACKLAP lever
to STOP. Raise cutting units by pulling back on lift control
levers. Hold levers back until cutting units are fully raised
(a squeal from the hydraulic system means cutting units are
fully raised). Lock cutting units in place with transport
latches. Be careful when driving between objects so you do
not accidentally damage the machine or cutting units.
Matching Ground Speed and Reel Speed
Vary reel speed (while maintaining constant ground speed)
to establish the best quality of cut for the area being
mowed. Reel speeds either too fast or too slow for
conditions may effect the quality of cut. Use the cutting
chart (Fig. 23) and decal on steering console as a guide for
initial adjustment of ground and reel speeds.