Adjusting The Motion-Control Damper; Adjusting The Motion-Control Neutral-Lock Pivot - Toro 74909TE Operator's Manual

Adjusting the Motion-Control
Damper
You can adjust the top damper mounting bolt to obtain a
more desired motion-control lever resistance. See
for mounting options.
Right motion-control lever shown
1. Torque the locknut to 23 N∙m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Figure 92
Figure 92
Adjusting the Motion-Control
Neutral-Lock Pivot
You can adjust the flanged nut to obtain the desired
motion-control lever resistance when you move them to
the N - position. See
EUTRAL LOCK
options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired feel.
Note: For more resistance, tighten the flanged nut.
Note: For less resistance, loosen the flanged nut
3. Tighten the jam nut.
1. Flanged nut
58
Figure 93 for adjustment
Figure 93
2. Jam nut