Cleaning; Cleaning Under The Mower; Cleaning The Suspension System; Disposing Of Waste - Toro 74909TE Operator's Manual

6 2
1
g015594
Figure 111
1. Bolt
2. Spacer
3. Locknut
4. Spring
3. Place the spacer and the spring onto grass deflector.
4. Place 1 J-hook end of the spring behind the deck edge.
Note: Make sure that 1 J-hook end of the spring is
installed behind the deck edge before installing the bolt
as shown in Figure 111.
5. Install the bolt and the nut.
6. Place 1 J-hook end of the spring around the grass
deflector (Figure 111).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the fully
down position.
4
7
3
5
5. Spring installed
6. Grass deflector
7. J-hook end of spring

Cleaning

Cleaning under the Mower

Service Interval: Before each use or daily
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the mower to the T
Cleaning the Suspension
System
Note: Do not clean the shock assemblies with pressurized
water (Figure 112).

Disposing of Waste

Engine oil, batteries, hydraulic fluid, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.
67
-
EUTRAL LOCK
position.
RANSPORT
Figure 112
position,
g030538