Lubrication; Greasing The Sprayer - Toro 41179 Operator's Manual

Figure 34
1. Front jacking points
The jacking point at the rear of the sprayer is on the rear
frame support, between the angle welds (Figure 35).
Figure 35
1. Rear jacking points

Lubrication

Greasing the Sprayer

Service Interval: Every 50 hours—Lubricate the pump.
Every 100 hours/Yearly (whichever
comes first)—Lubricate all grease
fittings.
Grease Type: No. 2 General Purpose Lithium Base
Grease
1. Wipe the grease fitting clean so that foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
The grease fittings positions are illustrated by the
following: Figure 37 through Figure 42.
Pump (Do not over grease)
1. Grease point
39
Figure 36