Setup - Toro 41179 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine
from the normal operating position.
Important: To use the sprayer, you must obtain and install a boom kit and nozzles . Contact your
Authorized Toro Distributor for information on the available boom kits and accessories. After you install
your booms and nozzles and before using the sprayer for the first time, adjust the boom bypass valves so
that the pressure and application rate remains the same for all booms when you turn one or more booms
off. Refer to Adjusting the Boom Bypass Valves section in the Operation section.
Without a boom kit installed, the sprayer may spray chemicals out of the boom valves, possibly injuring
bystanders or causing property damage.
Do not run the sprayer without a boom kit and nozzles installed.
Description
90 degree fitting
Quick coupler
Hose adapter
Fill receptacle bracket
Flange-head bolt, 5/16 x 3/4 inch
Anti-siphon hose
Spray Pro Monitor
Spray Pro Decal
Bracket
Flange-head bolt, 3/4 inch
Flange nut, 1/4 inch
Knob
Washer
Carriage bolt
Ignition key
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
Registration Card
Pre-delivery Inspection Sheet
Qty.
1
1
1
Install the anti-siphon fill receptacle.
1
1
1
1
1
1
2
Install the Spray-Pro monitor.
2
2
2
2
1
1
1
Read the manuals and view the training
1
material before operating the machine.
1
1
1
13
Use