Installing And Removing Attachments - Toro 22303 Operator's Manual

7. Install the cylinder locks over the hydraulic hoses and
secure them with the clevis pins and cotter pins (Fig.
17).
1
2
Figure 17
1. Hydraulic hoses
2. Cylinder locks
Installing and Removing
Attachments
Connecting an Attachment
Important
Use only Toro-approved attachments.
Attachments can change the stability and the operating
characteristics of the traction unit. The warranty of the
traction unit may be voided if used with unapproved
attachments.
Important
Before installing the attachment, ensure
that the mount plates are free of any dirt or debris and that
the pins rotate freely. If the pins do not rotate freely,
grease them; refer to Greasing the Traction Unit, page 23.
1. Position the attachment on a level surface with enough
space behind it to accommodate the traction unit.
2. Start the engine.
3. Tilt the attachment mount plate forward.
4. Position mount plate into the upper lip of the
attachment receiver plate (Fig. 18).
2
Figure 18
1. Mount plate
3
4
1
2
m–4601
3. Hairpin cotter
4. Clevis pin
1
m–4055
2. Receiver plate
20
5. Raise the loader arms while tilting back the mount
plate at the same time.
Important
The attachment should be raised enough
to clear the ground, and the mount plate should be
tilted all the way back.
6. Stop the engine.
7. Engage the quick attach pins, ensuring that they are
fully seated in the mount plate (Fig. 19).
Important If the pins do not rotate to the engaged
position, the mount plate is not fully aligned with the
holes in the attachment receiver plate. Check the receiver
plate and clean it if necessary.
3
1
2
Figure 19
1. Quick attach pins (shown
in engaged position)
Warning
If you do not fully seat the quick attach pins
through the attachment mount plate, the
attachment could fall off of the traction unit,
crushing you or bystanders.
Ensure that your quick attach pins are fully
seated in the attachment mount plate.
1. Position the attachment on a level surface with enough
space behind it to accommodate the traction unit.
2. Move the pump control lever to the turtle position.
m–5919
2. Disengaged position
3. Engaged position