Starting The Software - HP 3330B Software Manual

The software assumes that the 3330B is at its default address 4 This is
configured by jumpers S1 to S5 on the A6 assembly.
The software assumes that the 3570A is at its default address 1 This is
configured by jumpers 1 to 5 on the A33 assembly.
An optional plotter can be connected to the HPIB. The plotter should be set to
address 6

Starting the Software

At the DOS prompt type Bode [ret] or BodeNI [ret] depending on the version
being used. The opening screen will appear:
Parameters can be changed selecting with the up/down arrows and using page up and
page down to modify the value.
F1
Pressing F1 will cause a log graph to be drawn on the screen. The number of
cycles depends on the Start and Stop Frequencies. The Synthesizer is set to the
Start Frequency and Level. After 500ms the first reading is taken from the 3570A
depending on the parameters set in the RECEIVER section. After the reading a
new frequency is sent to the synthesizer. The frequencys are logrithamically