Toro 30410 Operator's Manual page 20

3. Remove the tensioning cap from the spindle shaft
(Fig. 10) and slide the spindle out of the castor arm. Put
the 2 shims (1/8 inch) onto the spindle shaft as they
were originally installed. These shims are required to
achieve a level across the entire width of the cutting
units. Slide the appropriate number of 1/2 inch spacers
(refer to the chart below) onto the spindle shaft to get
the desired height-of-cut; then slide the washer onto the
shaft.
Refer to the following chart to determine the combinations
of spacers for the setting.
Figure 11
4. Push the castor spindle through the front castor arm.
Install the shims (as they were originally installed) and
the remaining spacers onto the spindle shaft. Install the
tensioning cap to secure the assembly.
5. Remove the hairpin cotter and clevis pin securing the
height-of-cut chains to the rear of the cutting unit
(Fig. 12).
2
Figure 12
1. Height-of-cut chain
1
2. U-bolt
20
6. Mount the height-of-cut chains to the desired
height-of-cut hole (Fig. 13) with the clevis pin and
hairpin cotter.
Figure 13
Note: When using 1 in. (25 mm), 1-1/2 in. (38 mm), or
occasionally 2 in. (51 mm) height–of–cut, move the skids
and gage wheels to the highest holes.
Side Cutting Units
To adjust the height-of-cut on the side cutting units, add or
remove an equal number of spacers from the castor forks,
position the castor wheel axles in the high or low
height-of-cut holes in the castor forks, and secure the pivot
arms to the selected height-of-cut bracket holes.
1. Position the castor wheel axles in the same holes in all
of the castor forks (Fig. 14 & 16). Refer to the
following chart to determine the correct hole for the
setting.
2. Remove the tensioning cap from the spindle shaft
(Fig. 14) and slide the spindle out of castor arm. Put the
two shims (1/8 inch) onto spindle shaft as they were
originally installed. These shims are required to achieve
a level across the entire width of the cutting units. Slide
the appropriate number of 1/2 inch spacers onto the
spindle shaft to get the desired height-of-cut; then slide
the washer onto the shaft.