Toro 30410 Operator's Manual page 21

4
1
Figure 14
1. Castor wheel
2. Tensioning cap
3. Spacers
Refer to the following chart to determine the combinations
of spacers for the setting.
Figure 15
3. Push the castor spindle through the castor arm. Install
the shims (as originally installed) and the remaining
spacers onto the spindle shaft. Install the tensioning cap
to secure the assembly.
2
3
5
4. Shims
5. Axle mounting holes
21
4. Remove the hairpin cotter and clevis pins from the
castor pivot arms (Fig. 16).
5. Rotate tension rod to raise or lower pivot arm until
holes are aligned with selected height-of-cut bracket
holes in the cutting unit frame (Fig. 16 & 17)
6. Insert the clevis pins and install the hairpin cotters.
7. Rotate tension rod counterclockwise (finger tight) to put
tension on adjustment.
4
1
Figure 16
1. Castor pivot arm
2. Axle mounting holes
Figure 17
8. Remove the hairpin cotters and clevis pins securing the
damper links to the cutting unit brackets (Fig. 18).
Align the damper link holes with the selected
height-of-cut bracket holes in the cutting unit frame
(Fig. 19), insert the clevis pins, and install the hairpin
cotters.
3
2
3. Clevis pin & hair pin cotter
4. Tension rod