Toro 30426 Operator's Manual page 8

7. Slightly raise deck to remove tension from the
height-of-cut chains. Remove hair pin cotters and clevis
pins securing height-of-cut chains to rear of deck
(Fig. 4). Retain hair pin cotters and clevis pins for
re–installation of front deck
Figure 4
1. Height of cut chain
8. Lower deck. Remove bolts, washers and locknuts
securing each lift arm ball joint mount to cutting unit
castor arm tube (Fig. 5).
1
Figure 5
1. Lift arm ball joint mount (2)
9. Disconnect the hydraulic hoses from the fittings on the
hydraulic motor (center deck only) (Fig. 6).
1
Figure 6
1. Hydraulic motor
1
2
2. Clevis pin & hairpin cotter
1
Important Cap or plug hydraulic hoses and motor ports
to prevent contaminating system during installation of
brush or storage of deck.
10. Move mower deck away from traction unit.
11. Jack up the machine until front wheels are off the
ground. Use jack stands or block the machine to prevent
if from falling. Refer to Traction Unit Operator's
Manual for Jacking instructions.
12. To gain access to the lift arms, the front wheel and tire
assemblies must be removed.
13. Remove fasteners securing cylinder pin to lift arm.
Remove cylinder pin and disconnect cylinder end from
lift arm (Fig. 7).
3
2
1
Figure 7
1. Left lift arm
2. Lift cylinder
14. Remove nut securing lift arm pin to frame (Fig. 7).
15. Remove lift arm pin and remove lift arm. Repeat
procedure on opposite cylinder and lift arm.
8
4
3. Cylinder pin
4. Lift arm pin