Maintenance; Recommended Maintenance Schedule(S) - Toro 02750 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 50 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 400 hours
Every 500 hours
Every 800 hours
Before storage
Every 2 years
Maintenance Procedure
• Change the engine oil and filter.
• Change the transmission-oil filter.
• Change the hydraulic return filter.
• Check the engine speed (idle and full throttle).
• Check the tire pressure.
• Grease the bearings, bushings, and pivots (grease them immediately after every
washing regardless of the interval listed).
• Check the air-filter-blockage indicator.
• Check the engine-oil level.
• Check the tire pressure.
• Torque the wheel lug nuts.
• Check the level of the coolant in the cooling system.
• Remove debris from the screen, oil coolers, and radiator (more frequently in dirty
operating conditions).
• Check the safety interlock system.
• Check the hydraulic fluid level.
• Check the hydraulic lines and hoses for leaks, kinked lines, loose mounting supports,
wear, loose fittings, weather deterioration, and chemical deterioration.
• Check the fasteners of the machine.
• Check the cutting units.
• Check the forward/reverse travel pedal action.
• Grease the bearings, bushings, and pivots (grease them immediately after every
washing regardless of the interval listed).
• Check the condition of and clean the battery.
• Check the battery cable connections.
• Inspect the cooling system hoses.
• Check the condition and tension of the alternator belt.
• Change the engine oil and filter.
• Service the air cleaner. (More frequently in extremely dirty or dusty conditions)
• Check the fuel lines and connections.
• Replace the fuel filter canister.
• Check the engine speed (idle and full throttle).
• Check engine overheat warning system.
• Change the transmission-oil filter.
• Check the rear wheel alignment.
• Service the Hydraulic System
• Change the hydraulic return filter.
• Check hydraulic oil overheat warning system
• Drain and clean the fuel tank.
• Flush and replace the cooling system fluid.
• Adjust the engine valves (refer to the engine operator's manual).
• Drain and clean the fuel tank.
• Replace all moving hoses.
• Replace the transmission cable.
29