Adjusting The Height Of Cut - Toro 04652 Operator's Manual

4. Place the spacers onto the screws above or below the
roller brackets, as required
5. Secure the roller bracket and spacers to the underside
of the mounting flanges with the nuts previously
removed.
Note: The position of the rear roller to the reel is controlled
by the machining tolerances of the assembled components
and paralleling is not required.

Adjusting the Height of Cut

Use the following chart to determine which bedknife is best
suited for the desired height of cut.
Bedknife Part No.
Edgemax 115-1880
Micro-cut
(Standard)
Edgemax 115-1881
Tournament
(Optional)
Micro-cut 93-4262
(Optional)
Tournament 93-4263
(Optional)
Extended 108-4303
Micro-cut
(Optional)
Extended 108-4302
Tournament
(Optional)
Low-cut 93-4264
(Optional)
High-cut 94-6392
(Optional)
Fairway 63-8600
(Optional)
Fairway 112–7475
EdgeMax
(optional)
Note: For heights of cut greater than 9.5 mm (0.375 inch),
install the high-height-of-cut kit.
Adjusting the Height-of-Cut Gauge
Before adjusting the height of cut, set the height-of-cut gauge
as follows:
1. Loosen the nut on the gauge bar and set the adjusting
screw to the desired height of cut
Note: The distance between the bottom of the screw
head and the face of bar is the height of cut.
(Figure 13 or Figure 14).
Height-of-Cut
1.5 to 4.7 mm (0.062 to
0.188 inch)
3.1 to 12.7 mm (0.125 to
0.500 inch)
1.5 to 4.7 mm (0.062 to
0.188 inch)
3.1 to 12.7 mm (0.125 to
0.500 inch)
1.5 to 4.7 mm (0.062 to
0.188 inch)
3.1 to 12.7 mm (0.125 to
0.500 inch)
4.7 to 25.4 mm (0.188 to
1.00 inch)
7.9 to 25.4 mm (0.312 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
(Figure 15).
1. Gauge bar
2. Height-adjusting screw
2. Tighten the nut.
Adjusting the Height of Cut
1. Loosen the locknuts securing the height-of-cut arms to
the cutting-unit side plates
1. Height-of-cut arm
2. Locknut
2. Hook the screw head of the height-of-cut gauge onto
the right side of the cutting edge of the bedknife and
rest the rear end of the bar onto the rear of the roller
(Figure 17).
11
Figure 15
3. Nut
(Figure 16).
G020074
Figure 16
3. Adjusting screw