Table of Contents
Advertisement
Contents
Safety ........................................................................... 3
Hauling .................................................................. 4
Safety and Instructional Decals ................................. 4
Setup ............................................................................ 5
Installing the Roller.................................................. 5
Installing the Ball Studs ............................................ 5
Link ................................................................... 5
Repositioning the Counter Weights ............................ 6
Adjusting the Cutting Unit........................................ 7
Product Overview .......................................................... 8
Specifications ......................................................... 8
Attachments/Accessories......................................... 8
Operation ..................................................................... 8
Maintenance .................................................................. 9
Supporting the Cutting Unit...................................... 9
Adjusting the Bedknife-to-Reel Contact...................... 9
Adjusting the Rear-Roller Height ..............................10
Adjusting the Height of Cut .....................................11
Adjusting the Cut-Off Bar .......................................12
Servicing the Bedbar ...............................................12
Bedknife Specifications ...........................................14
Backlapping the Cutting Unit ...................................14
Safety
This machine has been designed in accordance with EN ISO
5395:2013 and ANSI B71.1-2012.
Hazard control and accident prevention are dependent
upon the awareness, concern, and proper training
of the personnel involved in the operation, transport,
maintenance, and storage of the machine. Improper
use or maintenance of the machine can result in injury
or death. To reduce the potential for injury or death,
comply with the following safety instructions.
•
Read, understand, and follow all instructions in the
traction-unit and cutting-unit operator's manuals before
operating the machine.
•
Never allow children to operate the machine. Do not
allow adults to operate the machine without proper
instruction. Only trained operators who have read this
manual should operate the machine.
•
Never operate the machine when under the influence of
drugs or alcohol.
•
Keep all shields and safety devices in place. If a shield,
safety device or decal is illegible or damaged, repair or
replace it before commencing operation. Also tighten
any loose nuts, bolts, and screws to ensure cutting unit is
in safe operating condition.
•
Wear appropriate clothing including substantial,
slip-resistant footwear, safety glasses, and hearing
protection. Tie back long hair. Do not wear jewelry.
•
Remove all debris or other objects that the cutting-unit
blades might pick up and throw. Keep all bystanders away
from the working area.
•
If the cutting blades strike a solid object or the unit
vibrates abnormally, stop and shut the engine off. Check
the cutting unit for damaged parts. Repair any damage
before starting the cutting unit.
•
Lower the cutting units to the ground and remove the key
from the ignition switch whenever you leave the machine.
•
Ensure that the machine is in safe operating condition by
keeping nuts, bolts, and screws tight.
•
Remove the key from ignition switch to prevent accidental
starting of the engine when servicing, adjusting, or storing
the machine.
•
Perform only those maintenance instructions described
in this manual. If the machine needs major repairs or you
need assistance, contact an Authorized Toro Distributor.
•
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement parts
and accessories made by other manufacturers could be
dangerous, and such use could void the product warranty.
3
Advertisement
Table of Contents
