Operation And Important Riding Points; Starting The Engine - Yamaha FJR1300AS Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

Read the Owner's Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
or injury.
5
EAU15951
TIP
This model is equipped with:
● a lean angle sensor to stop the en-
gine in case of a turnover. In this
EWA10271
case, the multi-function meter unit
indicates error code 30, but this is
not a malfunction. Turn the key to
"OFF" and then to "ON" to clear the
error code. Failing to do so will pre-
vent the engine from starting even
though the engine will crank when
pushing the start switch.
●
an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. In this case,
the multi-function meter unit indi-
cates error code 70, but this is not
a malfunction. Push the start
switch to clear the error code and
to restart the engine.
EAU47150

Starting the engine

Always apply the front or rear brake
while the main switch is in the "ON"
position and the transmission is in
gear. Otherwise, the vehicle may
suddenly start to move when the en-
gine is started, causing loss of con-
trol and possibly an accident.
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
●
●
1. Turn the key to "ON" and make
5-1
WARNING
The front or rear brake is applied
with the transmission in the neutral
position whether the sidestand is
up or down.
The front or rear brake is applied
with the transmission in gear and
the sidestand is up.
See page 3-47 for more informa-
tion.
sure that the start/engine stop
switch is set to " ".
The following warning lights and
indicator lights should come on for
a few seconds, then go off.
EAU55471
EWA16410