Checks After Engine Warm Up; Shifting; Stop Switches - Yamaha F15C Owner's Manual

if necessary. Consult your Yamaha
dealer if the cause for the low oil
pressure alert cannot be found.
[ECM01832]
EMU36532

Checks after engine warm up

EMU36542

Shifting

While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36981

Stop switches

Turn the main switch to "

engine stop button and make sure the en-
gine stops.
Confirm that removing the clip from the en-

gine shut-off switch stops the engine.
Confirm that the engine cannot be started

with the clip removed from the engine
shut-off switch.
EMU34563
Shifting
EWM00181
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01611
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
1. Pull the neutral interlock trigger up (if
equipped).
1. Neutral interlock trigger
2.
", or press the
Move the remote control lever / gear
shift lever firmly and crisply forward (for
forward gear) or backward (for reverse
gear) [about 35 (a detent can felt) for re-
mote control models]. Be sure to check
that the tilt lock lever is in the lock/down
position (if equipped) before operating in
reverse.
Operation
ZMU05541
44