sion from cavitation or ventilation, or other
damage.
Check the propeller shaft for damage.
Check the splines for wear or damage.
Check for fish line tangled around the pro-
peller shaft.
Check the propeller shaft oil seal for dam-
age.
EMU30663
Removing propeller
EMU29198
Spline models
1.
Straighten the cotter pin and pull it out
using a pair of pliers.
2.
Remove the propeller nut, washer, and
spacer (if equipped). WARNING! Do
not use your hand to hold the propel-
ler when loosening the propeller nut.
[EWM01891]
1. Cotter pin
2. Propeller nut
3. Washer
1
2
3
4
5
ZMU02062
4. Propeller
5. Thrust washer
3.
Remove
the
equipped), and thrust washer.
EMU30673
Installing propeller
EMU46120
Spline models
ECM00502
NOTICE
Make sure to use a new cotter pin and
bend the ends over securely. Otherwise,
the propeller could come off during oper-
ation and be lost.
1.
Apply Yamalube Marine Grease or a
corrosion resistant grease to the propel-
ler shaft.
2.
Install the spacer (if equipped), thrust
washer, washer (if equipped), and pro-
peller on the propeller shaft. NOTICE:
Make sure to install the thrust washer
before installing the propeller. Other-
wise, the lower case and propeller
boss could be damaged.
3.
Install the spacer (if equipped) and the
washer. Tighten the propeller nut to the
specified torque.
Maintenance
propeller,
washer
[ECM01882]
(if
70