MIGHTYMIG210 MOdelS: Thank you for purchasing a Sealey Welder. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance. IMPORTANT: BEFORE USING THIS PRODUCT, PLEASE READ THE INSTRUCTIONS CAREFULLY. MAKE CAREFUL NOTE OF SAFETY INSTRUCTIONS, WARNINGS AND CAUTIONS.
3.2.3 Slide the socket on the right hand handle mounting (3) over the free end SPECIFICATION, Model No: ............MIGHTYMIG170 of the handle tube and rotate the mounting downwards until it is resting Maximum Current: ..................170A on the front of the welder. Using two of the 25mm round headed bolts Wire Capacity steel: ..................5kg...
Page 4
Turn gas cup clockwise only and pull it off end of torch tip. WARNING! do not turn gas cup anti-clockwise, as this will damage the internal spring. d) Unscrew copper contact tip (right hand thread) to remove. Original Language Version MIGHTYMIG170, MIGHTYMIG190, MIGHTMIG210 Issue: 2 - 26/02/10...
Page 5
Note: dO NOT over tighten the clutch as this will cause wire feed problems and strain the motor. (Mightytmig170 is preset and has no direct clutch adjustment.) Original Language Version MIGHTYMIG170, MIGHTYMIG190, MIGHTMIG210 Issue: 2 - 26/02/10...
MACHINE IS SWITCHED OFF AT THE MAINS. IF WELDING A CAR, DISCONNECT THE BATTERY OR FIT AN ELECTRONIC CIRCUIT PROTECTOR. WE STRONGLY RECOMMEND THE USE OF SEALEY “PROSAF/12V OR 24V IN ORDER TO PROTECT SOPHISTICATED ELECTRONICS. ENSURE YOU HAVE READ & UNDERSTOOD THE ELECTRICAL SAFETY INSTRUCTIONS IN CHAPTER 1.
To keep the contact tip free from spatter, we recommend the use of Sealey anti-spatter spray (MIG/722308) available from your Sealey dealer. Refer to fig.12 and section 3.9 for removal and replacement.
Page 8
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode . Sole UK Distributor, Sealey Group, www.sealey.co.uk...