Removing The Display Bezel - Dell Inspiron 9200 Service Manual

1 display bezel 5 M2.5 x 3-mm screws (8)
2 M2.5 x 5-mm screws (6) 6 screw cover (2)
3 rubber display bumpers (6)
4 display panel

Removing the Display Bezel

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
1. Follow the instructions in "Before Working Inside Your
2. Remove the display assembly.
3. Remove the six rubber display bumpers.
4. Remove the two screw covers and the two shoulder screws.
5. Remove the six M2.5 x 5-mm screws around the display.
NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.
6. Use your fingers to separate the bezel from the top cover by pulling the right bottom corner of the bezel toward the bottom edge of the assembly to
clear the tab on the bottom right corner. (A) Then pull the bezel toward the toward the right edge of the assembly to clear the tab on the lower right
side. (B)
Computer."