Fitting the loop handle
•
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
129C/L
•
Fit the hardware as shown in the diagram and tighten.
Assembling and dismantling the
two-piece shaft
(129LK)
Assembly:
•
Loosen the coupling by turning the knob.
•
Align the tab of the attachment (A) with the arrow on
the coupling (B).
B
•
Push the attachment into the coupling until the
attachment snaps into place.
ASSEMBLY
129LK
A
•
Before using the unit, tighten the knob securely.
Dismantling:
•
Loosen the coupling by turning the knob (at least 3
times).
•
Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
C
10