Assembly; Operation - Husqvarna DH110 Operator's Manual

Introduction
WARNING:
safety chapter before you assemble the
product.
To install the handguard
1. Unfold the handguard clamp and put it on the shaft.
Make sure that the tab on the shaft is in the groove
on the bottom of the handguard clamp. (Fig. 20)
2. Fold the handguard clamp around the shaft and
tighten the 2 screws.
To adjust the harness
Always use the harness when you operate the product.
The harness gives maximum control during operation of
the product. The harness decreases the risk of tiredness
in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is approximately level with your right hip. (Fig.
16)
WARNING:
occurs, let go of the product and let it
fall to the ground.
Introduction
WARNING:
safety chapter before you use the product.
To do before you start the product
1. Examine the work area. Remove objects that can be
thrown out.
2. Examine the cutting attachment. Make sure that the
blades are sharp, and have no cracks and damages.
3. Make sure that the product works correctly. Examine
that all nuts and screws are tight.
4. Make sure that the handle and safety devices are
not damaged and are attached correctly. Do not
operate a product with missing parts or is changed
from its initial specification. Use protective gloves
when it is necessary.
5. Make sure that the covers are not damaged and are
attached correctly, before you operate the product.
2206 - 004 - 26.10.2023

Assembly

Read and understand the
If an emergency

Operation

Read and understand the
To install the storage hook on the wall
• Install the storage hook indoors.
• Keep the storage hook out of sunlight and in ambient
temperature of -10°C to 70°C.
• Install the storage hook on a drywall, wood or
concrete wall.
CAUTION:
can hold loads of minimum 30 kg.
• Install the storage hook on the wall with the 3 screws
(A). Use wall plugs (B) if it is necessary. (Fig. 21)
CAUTION:
screws are applicable for your wall type.
• Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
To hang the product on the storage
hook
• Hang the pole hedge trimmer attachment on the
storage hook as shown in the illustration. (Fig. 22)
To operate the product
• Start near the ground and move the product up
along the hedge when you cut the sides. (Fig. 23)
• Hold the product near your body for a stable work
position. (Fig. 24)
• Make sure that the tip of the cutting equipment does
not touch the ground.
• Be careful and work slowly until all the branches are
correctly cut.
To adjust the angle of the cutting
attachment
The cutting attachment can be adjusted in 6 different
positions.
1. Stop the product and remove the battery. (Fig. 25)
2. Hold the housing (A) tight.
3. Push and hold the lock buttons (B) at the 2 sides of
the housing.
4. Move the cutting attachment to the correct angle.
Make sure that the wall
Make sure that the
9