Charging The Handset; Channel Access/Auto Scan - Sanyo CLT-136 Instruction Manual

CHARGING THE HANDSET
1. Place the handset on the base station for
12 hours.
The CHARGE indicator lights.
*The base station must be connected to
AC power. (See page 11.)
2. Remove the handset from the base
station. Your telephone is now ready to
use.
CHARGE
indicator
When the BATT LOW indicator lights,
recharge the handset for a continuous 12
hours.
REPLACEMENT BATTERY
If the battery fails, replacement batteries are available from an authorized Sanyo
service center.
(Replacement battery: SANYO 3N-270AA)
STANDBY TIME
When the handset battery is fully charged, your Sanyo cordless phone offers up
to 3 weeks of continuous standby time. (Listed standby time is measured
under a situation in which the handset is kept in standby mode only-no phone
calls are made or received). Under normal usage conditions, recharging is
required more often.
10-CHANNEL ACCESS/AUTO SCAN
This cordless telephone automatically selects,
every time you answer or place a call using
the handset, a clear channel from 10 frequen-
cies available to transmit signals between the
base station and handset. If you notice
interference during a call, simply press the
~ button on the handset to access
a clear channel.
-6-
CHANNEL
0