Makita LS1016 Technical Information page 10

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Blade case, Motor section (cont.)
ASSEMBLING
(4) When assembling Motor section to Blade case, do as illustrated in Fig. 19.
Fig. 19
Handle
rib of
Blade case
Lead cover
Lead cover holder
[3]-2. Gear section (Spiral bevel gear 32, Helical gear 14, Helical gear 27, Helical gear 28)
DISASSEMBLING
(1) Lock Blade case at starting position as illustrated in Fig. 8. And remove Link plate as illustrated in Fig. 9.
(2) Remove Motor housing and Handle section as illustrated in Figs. 13 and 14. However, no need to remove Handle cover.
(3) Tilt Blade case in the direction of Motor housing at 45 degrees to prevent Gear portion from falling off. And then,
separate Gear section from Blade case as illustrated in Figs. 20 and 21.
Fig. 20
Turn Bearing retainer 14-23 with 1R361 counterclockwise.
Bearing retainer can be removed from Blade case.
Fig. 21
Remove the Screws illustrated
below and Bearing retainer 51.
Bearing
retainer 51
M5x16 Countersunk head screw (2pcs.)
1R361
Bearing
retainer 14-23
M5 Hex nut
Insert slotted screwdrivers between
Blade case and Bearing box and
lift up Bearing box as illustrated
below.
M5x16
Pan head
screw (3pcs.)
Pressing Handle toward the rib of Blade case,
assemble it to Motor housing by tightening
with 4x18 Tapping screws.
Motor housing
4x18
Tapping screw
Pressing Lead cover holder toward Lead cover,
assemble it to Handle complete by tightening
with 4x18 Tapping screw.
While pressing Shaft lock, remove M5 Hex nut
with Socket bit 8.
Gear section can be separated from
Blade case together with Bearing box.
shaft of
Helical
gear 14
Baring box
P 10/ 37
M5 Hex nut
Spring washer 5
Flat washer 5
Spiral bevel
gear 32
Helical gear 27
Helical gear 28