Volume Adjustment; Source Selection - Panasonic C1305L Operating Instructions Manual

General
[SOURCE] (Source)
selects a source.
[PWR] (Power)
toggles power on/off.
[MUTE]
toggles mute on/off.
Power On/Off
Set your car's ignition switch to the ACC or ON position.
Power on: Press [SOURCE] (PWR).
Power off: Hold down [SOURCE] (PWR) for

Source Selection

Press [SOURCE] to change the source.
Radio

Volume Adjustment

(Setting Range: 0 to 40, Default: 18)
Turn [VOL].
Mute
ON: Press [MUTE]. (
OFF: Press [MUTE] again.
[VOL] (Volume)
Remote Control Sensor
more than 1 second.
Disc Player
lights.)
Caution
• Set the volume level to low
enough before the AUX
connection is completed.
Failure to observe this, the
loud noise may come out and
damage your speakers and your
hearing.
SQ (Sound Quality)
SQ is a function that can call up various sound types at the
touch of button in accordance with your listening music type.
Press [SQ] to select the sound type (SQ) as
follows:
*
AUX IN
Notes:
•
If no operation takes place for more than 5 seconds in the
SQ selection mode, the display returns to the regular mode.
• Settings of SQ, bass and treble are infl uenced one another.
If such an infl uence causes distortion to the audio signal,
readjust bass/treble or volume.
• For further information on Bass, Treble, Balance and Fader
settings, refer to Audio Settings.
[SQ] (Sound Quality)
selects a sound type
(SQ).
*[AUX] (AUX IN) (3.5 mm  stereo)
From line output of external sound/audio
device (ex. Silicon-audio player, HDD
player, etc.)
*AUX IN:
(FLAT) fl at frequency response:
does not emphasize any part.
(Default)
(ROCK) speedy and heavy
sound:
exaggerates bass and treble.
(POP) wide-ranged and deep
sound:
slightly emphasizes bass and
treble.
(VOCAL) clear sound:
emphasizes middle tone and
slightly emphasizes treble.