Table of Contents
Advertisement
Parts And Their Functions
AC IN
4
1
Camera switching output connector
Camera switching output connector; connect it to the
frame switcher.
•
With 9H and L24H modes, the switch timing is below 4
fields. When using the frame switcher with these modes,
change the setting of the frame switcher so that the
switch timing is below 4 fields.
For details, refer to the operating instructions of the frame
switcher.
2
Audio input/output connectors
Audio input/output connectors (phono jacks)
3
Video input/output connectors
Video input/output connectors (BNC); connect the input
connector to the video camera, etc. and the output
connector to the TV monitor, etc.
4
AC IN connector
Connect the supplied power cord to an AC outlet.
5
Alarm input connector
Alarm recording input connector; connect it to the
external sensor.
6
COMMON terminal
7
Alarm reset input connector
Input connector for releasing alarm recording; a +4 to
+14 V DC voltage is required.
8
REC IN connector
Input connector for recording
1 2
3
CAMERA
SW OUT
IN
IN
AUDIO
VIDEO
OUT
OUT
ALARM RESET IN
TAPE END OUT
GND
WARNING/
ALARM IN
REC OUT
COMMON
REC IN
5
67
9
8
0
q
w
e
9
Tape end output connector
When the cassette tape comes to its end during recording,
the alarm device installed externally is activated.
0
WARNING/REC output connector
When trouble has occurred in the unit, the alarm device
installed externally is activated.
Error warning or recording low signal selected on the
menu screen 3 is output.
q
GND Terminal
This terminal is connected to the signal ground terminal
of the connected unit in order to reduce noise. It is not
connected to ground for safety purposes.
w
MIC input jack
Input jack (3 mm) for an external microphone.
This jack has precedence when signals are supplied
simultaneously to this jack and the audio input
connectors.
e
REMOTE control connector
For connecting the AG-A11 remote controller which is
available as an optional accessory.
r
RS-232C connector
With this connector, basic operations of the unit can be
controlled using a personal computer (etc.)
t
Battery installation area
Install the battery in this area. See "Lithium Battery" on
page 3.
8
BATTERY
PUSH OPEN
RS-232C
MIC
REMOTE
r
t
Advertisement
Table of Contents
