Synchronizing Time Code On Another Camera - JVC GY-HM600E Instructions Manual

4 Check the values and press the Set button
(R).
The time code is set and the screen returns
0
to the normal screen.
To cancel the setting, press the [CANCEL]
0
button.
Caution :
When the camera recorder is switched to Media
0
mode during editing, editing will be canceled
and the screen will close.
When editing the time code, operation of the
0
[FOCUS ASSIST/1] and [OIS/2] buttons that are
configured in [Main Menu] B [Camera
Function] B [User Switch Set] is disabled. The
[OIS/2] button functions as the number reset
button.
(A P95 [User Switch Set Item] )
Recording Time Code in Continuation of
the Recorded Time Code on SD Card
This camera recorder is equipped with the time
code reader.
1 Set [TC/UB] B [TC Generator] to "Regen".
When the camera recorder enters from
0
recording standby mode to recording mode,
it reads the time code already recorded on
the SD card and records the new time code
in continuation of that value.
The same data as the user's bit already
0
recorded on the SD card is recorded.
Memo :
When [TC/UB] B [TC Generator] is set to
0
"Regen", the framing mode of the time code
follows the settings in [TC/UB] B [Drop Frame]
instead of the clip settings.
(A P101 [ Drop Frame ] )
66
Synchronizing Time Code
on Another Camera
This camera recorder is equipped with a time code
input/output terminal ([TC] terminal).
Connect another camera recorder to the [TC]
terminal and synchronize to the time code.
1 Connect the [TC] terminal of the master
device with the [TC] terminal of the slave
device.
Set the [TC IN/OUT] switch of the master device
to "OUT", and the [TC IN/OUT] switch of the
slave device to "IN".
Master Device
Slave Device
(This Camera Recorder)
[OUT]
IN OUT
TC
[IN]
IN OUT
TC