Led Indications And Recommended Actions - HP MSA 2040 Troubleshooting Manual

Table 1 Events requiring FRU replacements scenarios (continued)
Event ID FRU
464 SFP
551 PSU

LED Indications and Recommended Actions

Table 2 LED Indications and recommended actions
Indicator
The enclosure front panel
Fault/Service
Required LED
Symptom
exceeded the capability of an FC
SFP.
A user inserted an unsupported
cable or SFP into the indicated
controller host port.
See "Power Supply Faults and Recommended Actions" (page 25)
Status
Off
Amber
Action Required
Replace with a supported SFP.
Cause
System is functioning
properly.
A fault condition
exists/occurred. If installing
an I/O module FRU, the
module has not gone online
and likely failed its self-test.
Action Required
No action required.
Verify the following:
The LEDs on the back of
the controller enclosure
to narrow the fault to a
FRU, connection, or both
The event log for specific
information regarding the
fault; follow any
Recommended Actions
If installing an IOM FRU,
try removing and
reinstalling the new IOM,
and check the event log
for errors
If the previous actions do
not resolve the fault, isolate
the fault, and contact an
authorized service provider
for assistance. Replacement
is necessary.
Events and LEDs 7