Measuring At Multiple Listening Positions (Multi Measure) - Yamaha RX-A3060 Owner's Manual

Measuring at multiple listening positions
(multi measure)
SOURCE SOURCE RECEIVER RECEIVER
When "Multi Position" is set to "Yes", follow the procedure below for
AV AV
1 1 2 2 3 3 4 4
measurement. It takes about 15 minutes to measure 8 listening
5 5 6 6 7 7 V-AUX V-AUX
positions.
AUDIO AUDIO
1 1 2 2 3 3
PHONO PHONO
Y
TUNER TUNER BLUETOOTH BLUETOOTH USB USB NET NET
• If any error message (such as E-1) or warning message (such as W-1) appears, see
MAIN MAIN 2 3 4 2 3 4
PARTY PARTY HDMI OUT HDMI OUT
ZONE ZONE
SCENE SCENE
• Do not use the microphone base until the corresponding message appear on the TV.
1 1 2 2 3 3 4 4
PROGRAM PROGRAM MUTE MUTE VOLUME VOLUME
TOP MENU TOP MENU POP-UP/MENU POP-UP/MENU
ON ON
OPTION OPTION
SCREEN SCREEN
Cursor keys
ENTER
ENTER
RETURN
RETURN DISPLAY DISPLAY
BAND BAND
MODE MODE
TUNING TUNING PRESET PRESET
SUR. DECODE SUR. DECODE STRAIGHT STRAIGHT
MOVIE MOVIE MUSIC MUSIC
ENHANCER ENHANCER PURE DIRECT PURE DIRECT
INFO INFO SLEEP SLEEP
1 1 2 2 3 3 4 4
5 5
6 6 7 7 8 8
MEMORY MEMORY
9 9 0 0 10 10 ENT ENT
TV TV
INPUT INPUT
TV VOL TV VOL TV CH TV CH
MUTE MUTE CODE SET CODE SET
"Error messages" (p.63) or "Warning messages" (p.64).
1
To start the measurement, use the Cursor keys to select
"Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER again to
start the measurement immediately.
X
To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the measurement at
the first position finishes.
2
Move the YPAO microphone to the next listening position
and press ENTER.
Repeat Step 2 until measurements at all listening positions (up to
8) have been taken.
3
When the measurements at the positions you want to
measure are completed, use the Cursor keys to select
"CANCEL" and press ENTER.
When you have taken measurements at 8 listening positions, the
following screen appears automatically.
(when angle/height measurement is disabled)
Proceed to Step 5.
(when angle/height measurement is enabled)
Proceed to Step 4.
59
En