Canon ae1 Installation Procedures Manual page 39

10) Mount the fixing plate (front) [l] and the other fix-
2. Connecting the Finisher
ing plate (rear) 121 that come with the puncher unit
<Finisher-AE l >
using four screws [3] (binding; M4 x 6).
1) Remove the two screws [I], and detach the inlet
guide [2]; then, remove the four screws [3], and de-
tach the right cover [4].
<Saddle Finisher-AE2>
1) Remove the two screws [I], and detach the right
front cover [2].
A
If the rubber sheet that comes with the buffer pass
unit is found attached to the pickup face of the
f i n -
isher, leave it as it is. If you need to attach a rubber
sheet newly, be sure it has not been used before.