Troubleshooting - Panasonic CZ-RTC3 Operating Instructions Manual

Troubleshooting

If operation does not start by pressing
Check the following before asking for repair.
When the [Centrally
controlled] message
is displayed
Blackout?
Is the circuit breaker
turned off?
Is [Assigning]
blinking?
Is [ ] displayed?
Alarm indication (e.g.)
Defective indoor unit No.
Cannot stop the
operation.
Or the unit starts to
run automatically
even if (Off) button
is pressed.
• If you need to contact for servicing, check the back cover of the operating instructions for indoor
units or outdoor units.
...
 Being centrally controlled, operation is not
possible.
 After recovery from blackout, press
again.
→If operation does not start, turn off the circuit
breaker and consult the dealer of purchase
about the symptom and Model No.
 Turn it on and press
→If operation does not start, turn off the circuit
breaker and consult the dealer of purchase
about the symptom and Model No.
 After blinking stops, press
→If operation does not start, turn off the circuit
breaker and consult the dealer of purchase
about the symptom and Model No.
 If any of the following alarm indications
appears, stop operation once and restart
approx. 1 minute later.
(Alarm indication, off)
[•E04 •E06 •P10 •P20 •H06]
→If the indication does not reappear, use the unit.
→If the indication reappears or an alarm
indication other than the above (combination of
numbers and characters such as E, F, H, L and
P) appears, stop operation, turn off the circuit
breaker and consult the dealer of purchase
about alarm indication, Model No. and indoor
unit No.
 Check if the outing function is activated or not.
( )
 Check control by central control device.
again.
again.
(EN)
41