3 DISASSEMBLY/ASSEMBLY INSTRUCTIONS
IHOW TO DISASSEMBLE THE MAIN UNIT.
Ref. No. 1A
Procedure 1A
Ref. No. 1B
Procedure 1A→ → → → 1B
Removal of the housing.
1. Set the hammering/drilling switching lever to the position
the speed/blow mode selection lever in between "H" and "S"
position.
2. Loosen the support handle and take it out from the unit.
3. Pluck the chuck cover depressing the chuck handle.
4. Remove 15 housing screws.
For assembling
NOTE :
Make sure to attach the dust preventive clothes or filters on the
housings.
Removal of the motor brush assembly.
1. Loosen 2 screws.
3
EY6813-U1
and