Clock Phase Adjustment; Adjusting The Zoom Ratio; Adjusting The Geometry - Panasonic PT-D12000U Operating Instructions Manual

Adjusting the position (continued)

Adjusting the zoom ratio

This adjusts the size of the projected pictures.
Press ▲▼ to select "ZOOM".
1.
ASPECT
ZOOM
CLOCK PHASE
2. Press ENTER.
• The "ZOOM" screen will be displayed.
ZOOM
MODE
INTERLOCKED
V
H
HV
Press ▲▼ to select "MODE".
3.
Press ◄► to switch "MODE".
4.
• The setting will change as follows each time
◄► is pressed.
INTERNAL
• INTERNAL:
Enlarges the size of the pictures to within the
default aspect ratio.
• FULL:
Enlarges the size of the pictures using the whole of
the display area selected with "SCREEN FORMAT".
Press ▲▼ to select
5.
"INTERLOCKED".
ZOOM
MODE
INTERLOCKED
V
H
HV
Press ◄► to switch
6.
"INTERLOCKED".
• The setting will change as follows each time
◄► is pressed.
OFF
• OFF :
The "V" and "H" settings are used as the vertical
and horizontal zoom ratios respectively.
• ON :
The zoom ratio is set to the "HV" setting. This
allows the pictures to be zoomed at equal vertical
and horizontal ratios.
62 – ENGLISH
•
•
DEFAULT
0
Clock phase adjustment achieves the best image
when the screen flickers or halos are observed
around contours.
INTERNAL
OFF
1.
100%
100%
100%
2.
FULL
3.
•
•
INTERNAL
•
OFF
100%
100%
100%
Square video can be projected onto a special shaped
screen using unique image processing technology.
1.
ON
2.
Note
When "ASPECT" is set to "THROUGH", "ZOOM"
will not appear.
When other than "DEFAULT" is selected for
"ASPECT", the "MODE" selection setting will not
appear.

Clock phase adjustment

Press ▲▼ to select "CLOCK
PHASE".
ZOOM
CLOCK PHASE
GEOMETORY
Press ◄► or ENTER.
• The "CLOCK PHASE" individual adjustment
screen will be displayed.
CLOCK PHASE
ADJUST
Press ◄► to adjust the level.
• The value changes from 0 to 31. Adjust so that
the amount of interference is at a minimum.
Note
No optimal value may be obtained if the output
of the PC to which the signal input is applied is
unstable.
No optimal value may be obtained if the total
number of dots is not correct.
The clock phase can be adjusted only when RGB
signal input is applied with RGB1 and RGB2 IN.

Adjusting the geometry

Press ▲▼ to select
"GEOMETRY".
ZOOM
CLOCK PHASE
GEOMETRY
Press ◄► to switch
"GEOMETRY".
• The setting will change as follows each time
◄► is pressed.
OFF
PC
0
OFF
0
0
OFF
KEYSTONE
CURVED