Panasonic KX-NS1000 Operating Manual page 288

3.1.3 Customising the Buttons
•
To enter programming mode when using a PS, refer to the documentation for your PS.
•
The buttons in the table below can only be set on certain flexible buttons, as follows:
–
Flexible buttons on PTs/Add-on Key Modules/PSs: all buttons can be set.
–
Flexible buttons on DSS Consoles: all buttons except CTI and Primary Directory Number
(PDN) buttons can be set.
–
Programmable feature (PF) buttons: only the One-touch Dialling button can be set.
•
For KX-UT series SIP phone users and S-PS users: You cannot customise the flexible
buttons with the following method from your phone. You can customise the flexible buttons
using Web Maintenance Console. For details, refer to "Customising the Flexible Buttons".
To enter the programming mode
PROG.
OR
PAUSE
Press PROGRAM
or PAUSE.
Button
Loop-CO (L-CO)
Group-CO (G-CO)
Single-CO (S-CO)
Direct Station Selection
(DSS)
One-touch Dialling
Incoming Call Distribution
Group (ICD Group)
Message
Message for Another
Extension
Call Forwarding (FWD)/Do
Not Disturb (DND)—Both
calls
FWD/DND—Outside calls
FWD/DND—Intercom calls
Group FWD—Both calls
288 Operating Manual
Press desired
flexible button.
+ Outside line group no. (2 digits)
#
+ Outside line no. (3 digits)
0
+ Extension no.
1
+ Desired no. (max. 32 digits)
*1 *2
2
3 0
+ delayed ringing time [0–7])
#
4 0
4 0
extension no.
4 1
4 2
4 3
4 4
To programme
To continue
programming
input
Follow
Press ENTER
programming input.
or STORE.
Programming Input
*12
+ Incoming call distribution group extension no. (+
+ Extension no./Incoming call distribution group
+ Incoming call distribution group extension no.
To exit
PROG.
OR
OR
PAUSE
Press PROGRAM
or PAUSE.
*3