Panasonic KX-TS520FX Operating Instructions

1 Getting Started
1-A Controls
Operating Instructions
    
 Memory sticker
Integrated Telephone System

Ringer indicator
KX-TS520FX
Model No. 
Auto dial {M1},
{M2}, {M3}

VOLUME {},
{}

{PAUSE}
    

{*} {TONE}
Accessory information
 Handset . . . . . . . . . . . . . . . . . one
 Handset cord . . . . . . . . . . . . . one
 Telephone line cord . . . . . . . . one
Please read these operating instructions before
using the unit and save them for future reference.
1-B Connections
LINE DATA 1
Connect the handset cord () to the handset
For your future reference
and the unit. Connect the telephone line
We recommend keeping a record of the following
cord until it clicks into the unit and telephone
information to assist with any repair under warranty. Handset
line jack (). After line connection, lift the
Serial No.
handset to check for a dial tone.
(found on the bottom of the unit)
2
Set the DIALING MODE selector to TONE.
Date of purchase  If you cannot dial,
Telephone
line cord set to PULSE.
Name and address of dealer
To single-line Handset cord
3
Set the RINGER selector to HIGH, LOW or OFF.
telephone jack
(Example : "HIGH" is selected.)
 When set to OFF, the unit
Attach your purchase receipt here.
will not ring but the ringer
indicator will still fl ashing.
Connecting a communication device
1-62, 4-chome, Minoshima, Hakata-ku,
Fukuoka 812-8531, Japan
If you connect a communication device (computer, modem, fax, answering machine, etc.) to
the telephone line, you can connect it through this unit using the DATA jack. After connecting
the handset and telephone line cord, connect the communication device telephone line cord to
the DATA jack.
 Make sure the communication device is not in use before using this unit (making calls, storing phone
numbers in memory etc.) or the communication device may not operate properly.
PNQX1358ZA FM0908YS0
2 Making/Answering Calls
2-A Making calls
1 To redial the last number dialed
Lift the handset and dial the phone number.
 DIALING MODE
Lift the handset  Press {REDIAL}.
selector
2
When you fi nish talking, place the handset
 {REDIAL} will dial the last number you called

RINGER selector on the cradle.
manually, not a One-Touch Dialer number (3-B).

{REDIAL}
To adjust the receiver volume (6 levels)
Press {} or {} repeatedly while talking.

{FLASH}  After hanging up, the volume level will be saved.

{PROGRAM}
2-B Answering calls
When a call is being received, the unit rings,  The ringer indicator will fl ash when
 a telephone number is dialed in PULSE mode,
the ringer indicator fl ashes quickly. You can
or
answer the call by simply lifting the handset.
 someone picks up or hangs up another phone
connected to the same phone line.
This is normal.
3 One-Touch Dialer
3-A Storing phone numbers in memory
You can store up to 3 phone numbers in the
If you misprogram
one-touch auto dial buttons {M1}, {M2} or {M3}.
Hang up  Restart from step 1.
Do not press any one-touch auto dial buttons
To erase a stored number
before storing to prevent misoperation.
Lift the handset  Press {PROGRAM} 
1 Lift the handset  Press {PROGRAM}.
 the one-touch auto dial button {M1}, {M2}
2
Press the one-touch auto dial button {M1}, or {M3} of the phone number to be erased 
TONE PULSE  {PAUSE}  {PROGRAM}  Hang up.
{M2} or {M3}.
DIALING MODE
3
Enter a phone number up to 21 digits. Memory sticker
4 Use the memory sticker as a name or phone
Press {PROGRAM}.
number index for the stored numbers.
5
When fi nished, hang up.
RINGER
 If a pause is required for dialing, press
HIGH OFF
LOW {PAUSE} in step 3. A pause stored in a phone
number counts as one digit (4-C).
3 One-Touch Dialer 5 Things You Should Know
3-B Dialing a stored number 5-A Wall mounting
1 1
Lift the handset. Press the tabs in the direction of the arrows
(), then remove the wall mounting adaptor
2
Press the one-touch auto dial button {M1}, {M2} or {M3}.
().
 {REDIAL} does not work for One-Touch Dialer.
To dial the number again, hang up and repeat steps 1 and 2.
 If the telephone line cord is disconnected more than 3 days, the stored numbers may be erased.
Store phone numbers again, if necessary.
4 Special Features
2
Tuck the telephone line cord inside the
wall mounting adaptor, and push it in the
direction of the arrow.
4-A For call waiting service users
 The word "UP WALL" should face upward.
To use call waiting, you must fi rst subscribe to the call waiting service of your service provider/
telephone company. This feature allows you to receive calls while you are already talking on the
phone. If you receive a call while on the phone, you will hear a call waiting tone.
1
Press {FLASH} to answer the 2nd call.
2
To switch between calls, press {FLASH}.
Note:
 Please contact your service provider/telephone company for details and availability of this service in your
area.
5-B Troubleshooting
4-B Temporary tone dialing (for rotary/pulse service users)
Problem
You can temporarily switch the dialing mode to tone when you need to access touch-tone The unit does not work.
services (for example, answering services, telephone banking services, etc.). Press {*} {TONE}
The call cannot be connected
before entering access numbers which require tone dialing. even if you dialed correctly.
The unit does not ring.
4-C Pause (for PBX/long distance service users)
You cannot store a phone
number in memory.
A pause is sometimes required when making calls using a PBX or long distance service.
Example: If you need to dial the line access number "9" when making outside calls with a PBX:
The other party suddenly
1
Lift the handset to start calling. cannot hear your voice during
a conversation.
2 {9}  {PAUSE}
You cannot redial by pressing
3
Dial the phone number. {REDIAL}.
Liquid or other form of
Note:
moisture has entered the unit.
 A 2.1 second pause is inserted each time {PAUSE} is pressed. Repeat as needed to create longer
pauses.
Wall Template
5 Things You Should Know
5-C For your safety
3 To prevent severe injury and lost of life/
Drive screws (not included) into the wall
using the wall template below. Connect the property, read this section carefully before
telephone line cord. Mount the unit and then using the product to ensure proper and safe
slide it down. operation of your product.
LINE
Screws
DATA WARNING
 To prevent the risk of fi re or electrical shock, do
not expose the product to rain or any type of
8.3 cm
moisture.
 Do not disassemble the product.
 Do not spill liquids (detergents, cleansers, etc.)
Hooks onto the telephone line cord plug, or allow it
To single-line
to become wet at all. This may cause a fi re.
telephone jack
If the telephone line cord plug becomes wet,
(LINE)
immediately pull it from the telephone wall jack,
To communication and do not use.
device (DATA)
CAUTION
 Never install telephone wiring during an electrical
To temporarily set the storm.
handset down during a  Never install telephone line jacks in wet locations
conversation, place it as unless the jack is specifi cally designed for wet
shown here. locations.
 Never touch uninsulated telephone wires or
terminals unless the telephone line has been
disconnected at the network interface.
 Use caution when installing or modifying
telephone lines.
Cause/solution
Important safety instructions
 Check the connections (1-B).
When using your product, basic safety precautions
 Check whether the DIALING MODE selector setting is correct or not
should always be followed to reduce the risk of fi re,
(1-B).
electric shock and injury to persons, including the
 The RINGER selector is set to OFF. Set to HIGH or LOW (1-B).
following :
 Confi rm the handset is off the cradle. 1. Do not use this product near water, for example,
 Do not enter a phone number more than 21 digits long, or the near bathtub, washbowl, kitchen sink or laundry
tub, in a wet basement or near a swimming pool.
entered number and the previously stored number will be cleared.
 {PROGRAM} was pressed during the conversation. Press
{PROGRAM} again.
5-D Specifi cations
 If the last number dialed was more than 31 digits long, the number
Power Source: From telephone line
will not be redialed correctly.
Dimensions (H x W x D): Approx. 95 mm  190 mm  196 mm
 Disconnect the telephone line cord from the unit. Leave to dry for
Mass (Weight): Approx. 518 g
at least 3 days. After the unit are completely dry, reconnect the
Operating conditions: 5°C–40°C, 20 %–80 % relative air humidity (dry)
telephone line cord.
Note:
 Design and specifi cations are subject to change without notice.
8.3 cm  The illustrations in these instructions may vary slightly from the actual product.
5 Things You Should Know
2. Avoid using a telephone (other than a cordless
type) during an electrical storm. There may be a
remote risk of electric shock from lightning.
3. Do not use the telephone to report a gas leak in
the vicinity of the leak.
Note:
SAVE THESE INSTRUCTIONS  This equipment is designed for use in Czech
Republic, Slovakia and Turkey.
Environment  In the event of problems, you should contact your
 The product should be kept free from excessive
equipment supplier in the fi rst instance.
smoke, dust, high temperature, and vibration.
 The product should not be exposed to direct
Declaration of Conformity:
sunlight.  Panasonic Communication Co., Ltd. declares that
 Do not place heavy objects on top of the product.
this equipment is in compliance with the essential
 The product should be kept away from heat
requirements and other relevant provisions of
sources such as radiators, cookers, etc. It should Radio & Telecommunications Terminal Equipment
not be placed in rooms where the temperature (R&TTE) Directive 1999/5/EC. Declarations of
is less than 5°C or greater than 40°C. Damp Conformity for the relevant Panasonic products
basement should also be avoided.
described in this manual are available for
download by visiting:
Routine care http://www.doc.panasonic.de
 Wipe the outer surface of the product with a
Contact to Authorised Representative:
soft moist cloth.
Panasonic Testing Centre
 Do not use benzine, thinner, or any abrasive
Panasonic Marketing Europe GmbH
powder.
Winsbergring 15, 22525 Hamburg, Germany
Notice for product disposal, transfer, or
return
 This product can store your private/confi dential
information. To protect your privacy/confi dentiality,
we recommend that you erase the information
such as one-touch dialer from the memory before
you dispose of, transfer, or return the product.
Copyright:
This material is copyrighted by Panasonic
Communications (Malaysia) Sdn. Bhd., and
may be reproduced for internal use only.
All other reproduction, in whole or in part,
is prohibited without the written consent of
Panasonic Communications (Malaysia) Sdn.
Bhd.
© 2008 Panasonic Communications
(Malaysia) Sdn. Bhd. All Rights Reserved.