After Use - Panasonic EH-TSA3F Operating Instructions Manual

5. Slide the power switch upwards to
turn on the appliance.
The steam is released after about 1 minute.
The hissing sound is due to electrical discharge.
The sound may be intermittent, depending on how
the steam is produced.
6. Use with your face at least 20 cm from
the tip of the lid.
If you cannot judge the distance, use the distance guide below.
To apply steam to your entire face, point at just above the chin.
If you have trouble adjusting the position of the steam on your face, try
adjusting the height of the table, chair or cushion.
When the remaining water is low, the way that the steam is emitted changes.
7. After using, switch the power to OFF.
After steam care, apply your regular basic skin-care products
to trap the moisture in your skin.

After Use

1. With the power turned off, let the steamer cool down
for at least 10 minutes.
Do not move the main unit.
2. Unplug the power cord from the power outlet and
the appliance plug from the main unit.
Bundle up the power cord for storage. Do not wrap it around the steamer.
When not using the
Note
If there are water droplets on the front main body, wipe them off with a
tissue or the like.
Failure to do so may cause discoloration.
3. Remove the aroma tablet and wipe off any water
droplets with a tissue.
Distance guide
Steam within this range is hot.
EN11
EH-TSA3F.indb 11-12 EH-TSA3F.indb 11-12
, skip to step 5.
4. Place the aroma tablet in the storage
pouch and close the zipper securely.
Remove as much air as possible.
5. Close the lid and remove the water
supply tank from the main unit.
Remove the tank in a water-safe location
as water droplets may drip from the tank.
6. Discard the water in the water
supply tank.
Wipe away any water on the surface of
the water supply tank.
Note
After using the steamer, be sure to throw
out the water remaining in the water
supply tank and in the steamer.
If not, water droplets may get mixed in with the
steam, limescale may form and unpleasant odors
may be produced.
7. Discard the water in the main unit.
While pressing the inclination switch, drain the water from the water outlet
along the arrow.
Even after draining the water, some water remains in the appliance.
This does not cause any sanitary problems since the water is boiled when
used the next time.
8. Attach the water supply tank to the main unit.
Push the water supply tank into the main unit until it clicks.
9. Use a towel, etc., to wipe any water droplets off the
main unit, then store the main unit in a dry place.
When not planning to use it for a long period of time (several weeks or
more), dry the steamer off thoroughly before storing it.
Be careful not to get burned.
Inclination
switch
Water outlet
EN12
2015/08/07 12:02:57 2015/08/07 12:02:57