Esfp Option For Host Ports; Locate The Sfp Transceivers; Install An Sfp Transceiver - HP MSA 2040 User Manual

E SFP option for host ports

Locate the SFP transceivers

Locate the qualified SFP options for your MSA 2040 SAN controller module within your product ship kit.
You can also obtain the part numbers using the QuickSpecs.
IMPORTANT:
important information pertaining to iSCSI SFPs.
The SFP transceiver (SFP) should look similar to the generic SFP shown in the figure below. Follow the
guidelines provided in
Controller module face plate
Align SFP for installation
(plug removed/actuator open)
Figure 40 Install a qualified SFP option
TIP: See the "Configuring host ports" topic within the SMU Reference Guide for information about
configuring MSA 2040 SAN host ports with host interface protocols of the same type or a combination of
types. Also see

Install an SFP transceiver

For each target MSA 2040 SAN host port, perform the following procedure to install an SFP. Refer to the
figure above when performing the steps.
1. Orient the SFP as shown above, and align it for insertion into the target host port.
The SFP should be positioned such that the actuator pivot-hinge is on top.
2. If the SFP has a plug, remove it before installing the transceiver. Retain the plug.
3. Flip the actuator open as shown in the figure (near the left detail view).
The actuator on your SFP option may look slightly different than the one shown, and it may not open to
a sweep greater than 90° (as shown in the figure).
4. Slide the SFP into the target host port until it locks into place.
5. Flip the actuator down, as indicated by the down-arrow next to the open actuator in the figure.
See the "HP MSA 2040 SAN Storage array and iSCSI SFPs Read This First" document for
"Electrostatic discharge" (page 93)
Target host port
"Using the CLI port and cable—known issues on Windows" (page
when installing an SFP.
Fibre-optic interface cable
Locate the SFP transceivers
Installed SFP
(actuator closed)
49).
95