1 Warning Caution: • Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70°F (30 - 40°C) higher. Please use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder- ing iron, please be careful not to heat too long.
4 Disassembly and Assembly Instructions 4.1. Disassembly Instructions Follow the procedure below to disassemble the main unit. 1. Remove the cap, the outer foil and the inner blade. 3. To remove the trimmer driving bar or the slit blade driving bar, press bars outward.
Page 8
5. Take out the battery from the chassis. 7. Move gently the linear motor assembly down and unhook it and remove the float springs from housing A. 6. Take out the tube holder. 8. Unsolder the lead wires from the module.
Page 9
4.2. Caution in Assembly NOTE: When reassembling, replace the new waterproof seal. Make sure whether there is NO foreign substance sticking around a part covered with waterproof seal. 1. Solder the lead wires with the module. 3. Make sure that the lead wires set in position to avoid NOTE: abnormal noise.
Page 10
4. Set the linear motor assembly on the housing A and slid- 6. Tighten six screws. ing it upward to hook. Confirm that the lead wire tube fits NOTE: Make sure to attach the connecting plate. to the housing A firmly and no foreign substance sticking around.
Page 11
8. Attach the bottom cover and tighten a screw. 10. Set the trimmer and tighten a screw. If the position is not properly, it makes the deformation of the hook. 9. Set the trimmer driving bar and the slit blade driving bar.
6 Exploded View and Replacement Parts List Model No. : ES8249 Exploded View...
Page 14
Model No. : ES8249 Parts List Ref. Safety Part No. Part Name & Description Q'ty Remarks WES8243X7158 PROTECTIVE CAP WES9161C OUTER FOIL WES9068PC INNER BLADE 1ST (for U.S.A.) WES9068C INNER BLADE 1ST (for Canada) WES8258L1007 LINEAR MOTOR ASSEMBLY WES8258L1087 TRIMMER DRIVING BAR...