Table of Contents
Advertisement
G
ALIGNMENT PROCEDURE
INSTRUMENTS
AND TOOLS
1. AM SIGNAL GENERATOR
2. FM SIGNAL GENERATOR
3. OSCILLOSCOPE
4. IF SWEEP GENERATOR
W/MARKER
5. DISTORTION
METER
6. WOW & FLUTTER METER
7. NONMETALLIC
ALIGNMENT
TOOLS
8. OUTPUT METER (VTVM)
IMPORTANT
1.
Connect the negative leads of the signal source and output indicator to the chassis ground unless
otherwise specified.
2.
The
signal
input should be kept as low as possible to avoid AGC and AFT action.
3.
The standard modulation
is 30?4. amplitude with 400Hz signal for AM and 22.5 KHz deviation with 400Hz
signal for FM.
TUNER ADJUSTMENTS
Use a plastic screwdriver
for adjustments.
.
Adjust the intermediate
frequency
of MW, LW and FM to the frequency
of ceramic filter.
Set of unit.
Supply voltage
:DC12V
Output load
: Speaker Terminal (8 ohm)
Standard output (Volume Control)
: 250mW (1V) at speaker terminal
Function switch
: RADIO
BASSXPANDER
switch
: OFF
PARTS LOCATION
,
,_r""%..,
TC1
TC4
\
~NTl
CTIO1
LI 08
-2-
- Quick Links:
- Tape Speed Adjustment
Hide quick links:
Advertisement
Table of Contents
