Epson Stylus pro 4000 Setup Manual page 7

7. After inserting all ink cartridge into each slot,
lower the ink lever. The printer starts initial
ink charging.
8. After approximately 2 minutes, ink lever
messages appear on the LCD. When a
message appears on the LCD, raise or lower
the ink levers accordingly until READY appears
on the LCD.
c
Caution:
Never do the following while the Pause light
is flashing; otherwise, damage may occur.
❏ Turn off the printer.
❏ Open the top cover.
❏ Remove the rear cover.
❏ Move the paper lever to the released
position.
❏ Remove the ink cartridges.
❏ Remove the maintenance tank.
❏ Unplug the power cord.
9. When READY appears on the LCD, the initial
ink charging is completed. Close the ink
compartment covers.
Note:
If you have installed 220 ml ink cartridges, do not
close the ink compartment covers.
Loading the Roll Paper
Attaching the roll paper to the spindle
When installing the roll paper onto the spindle,
follow these steps.
1. Slide the movable flange off the end of the
spindle.
2. When attaching roll paper with a 3-inch core,
keep the gray attachments attached.
If you are attaching roll paper with a 2-inch
core, remove them from the spindle.
Note:
Keep them in a safe place for future use.
3. Place the roll paper on a flat surface so that it
does not unwind. Slide the roll paper onto the
spindle and onto the flange until it fixes into
place.
Note:
Do not stand the spindle when attaching the roll
paper. It may cause a slant paper feeding.
4. Slide the movable flange (removed in step 1)
onto the spindle and into the end of the roll
paper until it fixes into place.
7